大香伊蕉在人线99国产图片_亚洲老汉色av_亚洲欧美AV中文无码二区_播放chinese中国女人露脸
            COMPANYHONNORORGANIZATION
               Position:Home | Trends
               
            GATE: external direct
            •; GATE: external direct (opposite side of the hinge). Flow direction should climb over the gasket side.
            •; EJECTION: ejector pins (ø; 10 mm) on bosses connected to the wall by a rib (thickness= 3 mm max) and other ejector pins on the bottom in bas-relief.
            •; SLIDES: no slides are necessary.
            •; MOULD PARTING: use the plane passing through cylinder axis and through the center of lateral appendage.
            •; GATE: on the side of cylinder (opposite side of appendage).
            •; SLIDES: nr. 2 horizontal slides:
            1. For cylindric internal part,
            2. For appendage internal part and for cylinder upper face (to the end of the radius).

            •; GATE: external direct (opposite side of the hinge). Flow direction should climb over the gasket side.
            澆口:外部方向(鉸鏈對面)。流向須爬過襯墊側。
            •; EJECTION: ejector pins (ø; 10 mm) on bosses connected to the wall by a rib (thickness= 3 mm max) and other ejector pins on the bottom in bas-relief.
            澆鑄:通過筋板(最大厚度= 3 mm)連接到墻板上的模板上的頂桿(ø; 10 mm)和在型腔底部上的其他頂桿。
            •; SLIDES: no slides are necessary.
            滑塊:不需要。
            •; MOULD PARTING: use the plane passing through cylinder axis and through the center of lateral appendage.
            模具分型面:利用通過圓柱軸線和側面附加件的中心的平面
            •; GATE: on the side of cylinder (opposite side of appendage).
            澆口:圓柱的側面(附件的對面)
            •; SLIDES: nr. 2 horizontal slides:
            滑塊:2號水平滑塊
            1. For cylindric internal part,
            圓柱內部件
            2. For appendage internal part and for cylinder upper face (to the end of the radius).
            附件內部件和圓柱頂面(到圓弧的端部)
            PYRIGHT @ Fujian Fuzhou Chengchang Machinery Co,.Ltd ALL RIGHTS RESERVED
            WEBSITE:www.sluasi.com